Popular
- Allows devices such as vibrating pillow alarms or vibrating radio/paging devices to be connected to an AlarmSense system.
- Can also be used to monitor and switch conventional sounders and visual indicators.
- Suitable for use with C-TEC’s CFP AlarmSense range of 2-8 Zone Two-Wire Fire Panels.
- Operates in three configurations:-
- (1) relay activation places the AlarmSense Zone voltage across the output terminals.
- (2) relay activation reverses the polarity of the AlarmSense Zone voltage across the output terminals (to allow the use of monitored conventional sounders fitted with series diodes).
- (3) Two sets of volt-free contacts for use with door closure units, etc.
- Relay can be set to priority or non-priority by means of a DIL switch.
| Protocol/compatibility | Suitable for use with C-TEC’s CFP AlarmSense range of 2-8 Zone Two-Wire Fire Panels. |
| Supply/operating voltage | 9 to 33V DC. (Relay operation voltage less than 18V; Relay reset voltage less than 15V). |
| Quiescent current | 20µA. |
| Product dimensions (mm) | 65 W x 45 H x 25 D mm. |
| IP Rating | TBC. |
| Weight | 35g. |
| Properties | Relay contact ratings 1A @ 30VDC. |
| Operating conditions/temperature | -40ºC to +70ºC. |
| Notes | Alarm relay resets on silence. |
| Dimensions | 2.5 × 6.5 × 4.5 cm |
|---|
Related products
-
APOLLO AlarmSense Base Sounder/Visual Indicator Part No. 45681-509APO
Read more- Will accept any AlarmSense fire detector to provide fire detection and an audible AND visual alarm warning signal at the same point.
- 70d-87dB(A) sound output (visual indicator activates with sounder).
- Certified to EN54-3 by UL International (UK) Limited.
- Suitable for use with C-TEC’s CFP AlarmSense range of 2-8 Zone Two-Wire Fire Panels.
- AlarmSense priority/non priority signal recognition
- Detects the removal of a detector head and reports a fault
- Continues to work during unauthorised removal of detector.
- High and low volume ranges.
- Red and white caps available for stand-alone use.
- Can also be purchased as part of a detector/sounder visual indicator base combination (see Combination AlarmSense Devices section below).
-
Gent 4 ZONE CONVENTIONAL PANEL, EN54 LESS BATTERIES (13270-04LB)
₦235,500.00Add to cartDESCRIPTION
Gent 13270-04LB 4 Zone Conventional Xenex Fire Panel
BSI approved to EN54: Parts 2 & 4, the Xenex control panel can be used on installations meeting BS 5839:Part1. Control panel options for 2-8 zones can be specified.
Designed to simplify system installation, each Xenex panel contains an integral power supply and battery support to drive up to 8 alarm sounder circuits, 2 auxiliary relay contacts, a zone disablement facility and also one-man test and commissioning features.
-
Zeta Infinity 8 Conventional 1 Zone Fire Alarm Panel IN1
₦127,000.00Add to cartDESCRIPTION
The Infinity 8 control panel is housed in the
most attractive, modern designed, flame
retardent ABS enclosure, utilising a switch
mode power supply. It has a fully removable
front cover which improves ease of access for
cable installations.
The Infinity 8 panel can also be ordered with a metal back
box facilitating upto 7ah batteries to fit within the panel
housing. To order this version add “/M” to the end of the
model number (i.e. IN1/M, IN2/M, etc.) -
C-TEC ActiV Conventional Hi-Output W-2.75-9 Wall VAD c/w 100dB(A) Sounder (shallow base) Part No. BF433C/CC/SR
Read more- Third-party certified to EN54-3 (Sounders) and EN54-23 (VADs).
- Provides ‘W-2.75-9’ rated light distribution when wall mounted (min. 0.4 lux over a 2.75 x 9m cuboid area). Also rated as a W-4-4 VAD.
- Impressive 100dB(A) sound output @ 1m.
- Includes 31 selectable primary tones and an optional secondary tone.
- Two volume levels (high and low)
- Three selectable VAD flash rates (0.5Hz, 1Hz, OFF)
- Alarm Current at 30Vdc = 12.2mA (0.5Hz) or 19.5mA (1Hz)
- Alarm Current at 18Vdc = 14.5mA (0.5Hz) or 25mA (1Hz)
- IP21C rated.
- Manufactured in the UK by C-TEC.
Know Us
Safetech.hub is the newest online platform envisioned to provide 24/7 online platform for integrators, installers, and end users of Extra Low Voltage (ELV) systems in Nigeria
Read More
Reviews
There are no reviews yet.