ZETA Base for Intrinsically Safe Flame Detector (ZIS-33)

Related products

• 

  wishlist

  Texecom EXD Buzzer TCA-0005

  EXD Buzzer
  The Exd Buzzer is an explosion proof buzzer designed
  for use in hazardous areas where a distinctive signal is
  required. Certified to ATEX II 2G Exd e IIC T6, it is suitable for
  use in Zone 1 and Zone 2 areas.
  Producing a tone with low frequency, it cuts through
  background noise more effectively than many other
  devices of a similar output.
  Mounted in a rugged reinforced polyester case and
  weatherproof to IP66, it is suitable for use in the most
  arduous conditions.

  Read more
• 

  wishlist

  Zeta Fyreye MKII Diode Base

  ₦1,500.00

  DESCRIPTION

  Fyreye MKII Diode Base

  Low profile or deep diode mounting base for the Fyreye MKII range of conventional detectors.

  Add to cart
• 

  wishlist

  Gent Flush Manual Call Point (XENS-850) 470 Ohms Glass

  Gent XENS-850 Flush Manual Call Point 470 Ohms Glass

  Gent Flush Manual Call Point are designed to provide a manual alarm interface to conventional fire alarm control panels. All call points are supplied in the standard red colour and are available in semi-flush mounting or surface mounting options. The manual call points are all with a 470 Ohm resistor and Normally Open contact, complete with glass.

  Both break glass, and resettable operating elements can be used in the standard unit by a yellow strip on the element which becomes visible when activated.

  With the addition of a hinged transparent cover the element may be protected against accidental operation.

  A specialist test key may be inserted into the bottom of the unit to lower the glass and release the micro-switch and thus a full functional test is achieved.

  Read more
• 

  wishlist

  HORING LIH AH-0621 UL Photoelectric Smoke Detector

  • UL Listed.
  • The standard detector is 2-wire or 3-wire with base.
  • For 4-wire type just add one relay output module on 3-wire base. Simple and easy module placement enables wider application.
  • Twin-color LED display enables viewer to easily identify the current status of detector.
  • Contacts material is highly acid-resistant and rust-resistant.
  • Detector is made of high endurance, solid and colorfast Fire-proof plastic.
  • Non-loosening screws on base terminal for easy installation.
  • Detector has passed strict EMC test, which greatly eliminates false alarms caused by interference from nearby sources.

  Read more