Welcome to Top Store

Cart

Your Cart is Empty

Back To Shop

Category: Electric Lock

The electric lock operates by means of an electric current. Sometimes stand-alone with an electronic control assembly mounted directly to the lock. Electric locks use magnets, solenoids, or motors to actuate the lock by either supplying or removing power. Connected to an access control system. Deactivated or opened by authentication, without the use of a traditional physical key.

Remotely monitored and controlled, both to lock and to unlock. The most basic type of electronic lock is a magnetic lock. Maglocks are simple to install and are very attack-resistant. Improperly installed or maintained mag locks can fall on people. One must unlock the mag lock to both enter and leave

Showing all 4 results

  • SOCA SL 100A Dead Bolt

    15,000.00

    SL-100 has its own micro-computer control and detection. It is strongly suggested to use its own door open point (N.O. point) to open door and do not turn its power off (N.C. point) to open door.

    Add to cart
  • SOCA SL 100B Dead Bolt

    15,000.00
    • Built-in door open or door close state detection output point (250mA: N.C./ N.O.).
    • Special wearable design. Mechanic life of more than 1,000,000 times.
    • Fail-safe type and MOV surge protection.
    • Micro computer door position detection and current control to prevent error action and lower the lock’s temperature.
    Add to cart
  • SOCA SL-100D Dead Bolt Lock ( for automatic door)

    15,000.00
    • SL- 100D
      Power supply: DC 12V
      Without door position detection output
    • SL- 100DA
      Power supply: DC 12V
      With N.O. door position detection output
    Select options
  • SOCA SL-130 Dead Bolt Lock ( All purpose type )

    13,000.00
    • SL-130A
      N.C. door position detection output
      Power Supply: DC12V
    • SL-130U
      Door position detection and bolt
      position (N.C. & N.O.) output points
      Power Supply: DC12~24V
    • Please note that this electric lock has an oval cylinder and its width is 5.8cm. Therefore, the best position to install is at the center of the door leaf (not door frame)
    Add to cart

Cart

Your Cart is Empty

Back To Shop