Gent XENS-FLAP Replacement Mouldings and Cover Plates

Related products

• 

  wishlist

  C-TEC ActiV Conventional C-3-8.5 Base VAD c/w 96dB(A) Sounder Part No. BF456C/CC/W

  • • • Third-party certified to EN54-3 (Sounders) and EN54-23 (VADs).
      • Provides ‘O-R-3-2.5-17’ light distribution.
      • Ideally suited for use in corridors and other rectangular areas.
      • Impressive 96dB(A) sound output @ 1m.
      • Includes 31 selectable primary tones and an optional secondary tone.
      • Two volume levels (high and low)
      • Three selectable VAD flash rates (0.5Hz, 1Hz, OFF)
      • Alarm Current at 30Vdc = 12.2mA (0.5Hz) or 19.5mA (1Hz)
      • Alarm Current at 18Vdc = 14.5mA (0.5Hz) or 25mA (1Hz)
      • Optional BF330CTLIDW white or BF330CTLIDR red cap available for stand-alone use.
      • Supplied with a BF431QCP quick connect plate and detector spur wires.
      • IP21C rated.

       

      • Download Images
      • Download datasheet

  Read more
• 

  wishlist

  Zeta Fyreye MkII Conventional Heat Detectors MKII-HF/CS90

  ₦9,500.00

  DESCRIPTION

  The Fyreye Rate of Rise heat detectors (MKII-HFCS90) use a thermistor arrangement to sense a quick rise in
  temperature and also a final threshold temperature of 90°C. The Fyreye fixed heat detector (MKII-HF/CS90) has a single thermistor arrangement that gives an alarm at a temperature of 90°C.
  There are 4 types of mounting base available; standard or deep and with or without diode.

  Add to cart
• 

  wishlist

  HORING LIH AH-0621 UL Photoelectric Smoke Detector

  • UL Listed.
  • The standard detector is 2-wire or 3-wire with base.
  • For 4-wire type just add one relay output module on 3-wire base. Simple and easy module placement enables wider application.
  • Twin-color LED display enables viewer to easily identify the current status of detector.
  • Contacts material is highly acid-resistant and rust-resistant.
  • Detector is made of high endurance, solid and colorfast Fire-proof plastic.
  • Non-loosening screws on base terminal for easy installation.
  • Detector has passed strict EMC test, which greatly eliminates false alarms caused by interference from nearby sources.

  Read more
• 

  wishlist

  Gent Flush Manual Call Point (XENS-850) 470 Ohms Glass

  Gent XENS-850 Flush Manual Call Point 470 Ohms Glass

  Gent Flush Manual Call Point are designed to provide a manual alarm interface to conventional fire alarm control panels. All call points are supplied in the standard red colour and are available in semi-flush mounting or surface mounting options. The manual call points are all with a 470 Ohm resistor and Normally Open contact, complete with glass.

  Both break glass, and resettable operating elements can be used in the standard unit by a yellow strip on the element which becomes visible when activated.

  With the addition of a hinged transparent cover the element may be protected against accidental operation.

  A specialist test key may be inserted into the bottom of the unit to lower the glass and release the micro-switch and thus a full functional test is achieved.

  Read more