Gent XENS-MCB-8 Replacement PCB Assembly

Related products

• 

  wishlist

  APOLLO AlarmSense Base Sounder/Visual Indicator Part No. 45681-509APO

  • Will accept any AlarmSense fire detector to provide fire detection and an audible AND visual alarm warning signal at the same point.
  • 70d-87dB(A) sound output (visual indicator activates with sounder).
  • Certified to EN54-3 by UL International (UK) Limited.
  • Suitable for use with C-TEC’s CFP AlarmSense range of 2-8 Zone Two-Wire Fire Panels.
  • AlarmSense priority/non priority signal recognition
  • Detects the removal of a detector head and reports a fault
  • Continues to work during unauthorised removal of detector.
  • High and low volume ranges.
  • Red and white caps available for stand-alone use.
  • Can also be purchased as part of a detector/sounder visual indicator base combination (see Combination AlarmSense Devices section below).

  • Download datasheet

  Read more
• Sale!

  wishlist

  Zeta Fyreye MkII Conventional Heat Detectors MKII-HF C/W Base

  ₦17,000.00 ₦15,000.00

  DESCRIPTION

  The Fyreye fixed heat detector (MKII-HF) has a
  single thermistor arrangement that gives an alarm at a
  temperature of 57°C.
  There are 4 types of mounting base available; standard
  or deep and with or without diode.

  Add to cart
• 

  wishlist

  C-TEC ActiV Conventional Base Voice Sounder Part No. BF454C/CC/W

  • • • Superb sound intelligibility.
      • Choose from two evacuation voice messages and four evacuation alarm tones (your selected evacuation message will be preceded by the selected tone).
      • Alarm Current at 30Vdc = 10mA.
      • Alarm Current at 18Vdc = 8mA.
      • Optional BF330CTLIDW white or BF330CTLIDR red cap available for stand-alone use.
      • Supplied with a BF431QCP quick connect plate and detector spur wires.
      • IP21C rated.
      • Download datasheet

  Read more
• 

  wishlist

  Gent Flush Manual Call Point (XENS-850) 470 Ohms Glass

  Gent XENS-850 Flush Manual Call Point 470 Ohms Glass

  Gent Flush Manual Call Point are designed to provide a manual alarm interface to conventional fire alarm control panels. All call points are supplied in the standard red colour and are available in semi-flush mounting or surface mounting options. The manual call points are all with a 470 Ohm resistor and Normally Open contact, complete with glass.

  Both break glass, and resettable operating elements can be used in the standard unit by a yellow strip on the element which becomes visible when activated.

  With the addition of a hinged transparent cover the element may be protected against accidental operation.

  A specialist test key may be inserted into the bottom of the unit to lower the glass and release the micro-switch and thus a full functional test is achieved.

  Read more