Popular
-
Gent Fire Alarm System Set of Keys for Key Switch Interface and MCP
-
Gent Fire Alarm Vigilon Manual Call Point with Glass Element and Protective Cover (Excludes Back Box)
-
Cutting-Edge Velocity Zeta Aspiration Smoke Detection Fire Alarm Panel
-
GENT ADDRESSABLE FIRE ALARM 1 TO 6 LOOP CONTROL PANEL
₦5,455,000.00
-
TEXECOM VERITAS IMPAQ E BURGLAR ALARM VIBRATION DETECTOR- WHITE
₦18,500.00
Category: Sounder, Voice sounder & VADs
Showing 1–16 of 29 results
-
Out of StockAPOLLO ADDRESSABLE FIRE ALARM XP95 OPEN-AREA VAD CAT. C – WHITE BODY (WHITE FLASH) (C-3-15) – ISOLATOR KIT 55000-748APO
₦0.00Read moreThe XP95 Open-Area VAD Cat. C is specifically designed for use on a ceiling. These devices are used to supplement sounders in areas which carry the risk that sounders will not be heard.
- Uses high intensity LED
- EN 54-23 Compliant Category C VAD
- Flash rate 0.5Hz
- Fault signal if LED check failed
- Locking mechanism (grub screw)
- Wide angle of visibility
- Synchronised flash rates with the Apollo Protocol
-
Out of StockC-TECH ActiV Conventional FIRE ALARM SYSTEM C-3-8.5 Base VAD c/w 96dB(A) Sounder Part No. BF456C/CC/W
₦0.00Read more-
-
- Third-party certified to EN54-3 (Sounders) and EN54-23 (VADs).
- Provides ‘O-R-3-2.5-17’ light distribution.
- Ideally suited for use in corridors and other rectangular areas.
- Impressive 96dB(A) sound output @ 1m.
- Includes 31 selectable primary tones and an optional secondary tone.
- Two volume levels (high and low)
- Three selectable VAD flash rates (0.5Hz, 1Hz, OFF)
- Alarm Current at 30Vdc = 12.2mA (0.5Hz) or 19.5mA (1Hz)
- Alarm Current at 18Vdc = 14.5mA (0.5Hz) or 25mA (1Hz)
- Optional BF330CTLIDW white or BF330CTLIDR red cap available for stand-alone use.
- Supplied with a BF431QCP quick connect plate and detector spur wires.
- IP21C rated.
-
-
-
Out of StockConventional Sounder Isolator Controller Part No. BF365SC
Read more- Designed to meet requirement 17.9.2c of Dutch standard NEN2575.
- BSI certified to EN54 parts 17 & 18.
- Easily interfaced to a conventional fire alarm sounder circuit.
- Allows low-cost, non-fire resistant sounder circuit cabling to be used when used in conjunction with our BF365IM Isolator Modules (subject to fire officer approval).
- Wiring must be made in a loop arrangement, beginning and ending at the controller.
- If a wiring fault should occur, the Module(s) nearest to the faulty section of cabling will, if needed, isolate this section. As the Modules are driven from each direction, any loss of cable integrity will have no effect on the functionality of the actual sounders.
- Fits on standard UK 25mm flush or surface mount back boxes
-
GENT by Honeywell CONVENTIONAL FIRE ALARM 240V Electronic Bell 155 x 85m
₦12,500.00Add to cartManufactured by Honeywell Gent, from the Gent 240V ac 50-60Hz 30mA IP55 Electronic Bell 155 x 85m is 6 inches and weather resistant. As well as being perfect for fire installations it can also be used in security applications. It can be mounted be mounted on the wall or the ceiling – it’s truly reliable. …
GENT by Honeywell CONVENTIONAL FIRE ALARM 240V Electronic Bell 155 x 85mRead More
-
Out of StockGent Conventional Fire Alarm System-Red Base – White Flash; IP65 Base CWST-RW-W5 VAD
Read moreGent CWST-RW-W5 VAD Red Base – White Flash & IP65 Base
CWST-RW-W5 features high output LEDs, advanced optics and an innovative lens design, providing outstanding Omni-directional light coverage at low current draw. Specifically designed for, and approved to meet EN54-23. The CWST-RW-W5 delivers outstanding quality, reliability and long operational life. Weatherproof base provides IP65 for external use applications.
-
Out of StockGent Conventional Fire Alarm White Sounder with Low Profile Base ( CWSO-WW-S1)
Read moreGent CWSO-WW-S1 White Sounder with Low Profile Base
Gent’s non-addressable sounder is a high quality device designed to alert building occupants of an emergency. The product features a new folded horn design which provides outstanding sound output at low current draw.
-
Out of StockGent Fire Alarm Electronic 2way Sounder White C3-SN-W
₦0.00Read moreLow profile GENT sounder, ideal for use in environments where aesthetics should be discrete as possible. The GENT S3-SN-R Electronic 2 way Sounder White is rated at 100 dBA but can be remotely configured using the HandiLink IR remote control to turn on individual sounders when in commissioning mode and to adjust the volume. Access …
Gent Fire Alarm Electronic 2way Sounder White C3-SN-WRead More
-
Gent Fire Alarm S4 Heat Detector with Sounder – S4-780-S GEN
₦35,000.00Add to cartGent S4 Heat Detector with Sounder – S4-780-S
The S4-780-S Heat Sensor with Sounder is a Gent Vigilon S-Quad sensor with a unique combination of sensing elements to provide quick, intelligent fire decisions. Heat detection levels are fully programmable. This allows it to be configured to filter specific risks resulting in significantly reduced false alarms.
-
Out of StockGent Fire Alarm 6 inch Fire Red Ball Sounder 24v Dc 74430-88NM
₦0.00Read more- Designed with a modern feel
- Has a loud ring output
- There’s an option of a weatherproof kit
- All parts clip together to assemble
-
Out of Stock
Gent Fire Alarm Electronic 2way Sounder Red C3-SN-R
₦0.00Read moreLow profile GENT sounder, ideal for use in environments where aesthetics should be discrete as possible. The GENT S3-SN-R Electronic 2 way Sounder Red is rated at 100 dBA but can be remotely configured using the HandiLink IR remote control to turn on individual sounders when in commissioning mode and to adjust the volume. Access is no …
Gent Fire Alarm Electronic 2way Sounder Red C3-SN-RRead More
-
Gent Fire Alarm Electronic Solenoid Bell 24V DC, Red Weather Resistant IP44 (74432-88NM)
₦12,500.00Add to cartAn EN 54-3 compliant electronic bell for a wide range of applications. Available in red or grey metal casing and is suitable for both semi flush and surface mounting. Honeywell Gent offers an electronic bell for a wide range of applications. The combination of a miniature solenoid with an integrated control circuit allows excellent sound coverage, minimum current consumption and increased reliability. The improved aesthetics make the bell suitable for all applications including the most prestigious locations.
-
Out of StockGent Fire Alarm Key Operated, Surface Mounted C/w Back XENS-807
Read moreOur conventional manual call points are designed to provide a manual
alarm interface to conventional fi re alarm control panels. All call points
are supplied in the standard red colour and are available in semi-fl ush
mounting or surface mounting options. The manual call points are all with
a 470 Ohm resistor and Normally Open contact, complete with glass.
Both break glass, and resettable operating elements can be used in the
standard unit by a yellow strip on the element which becomes visible when
activated. -
Gent Fire Alarm S3 Red Body Voice Sounder High Power with Red VAD – S3-V-VAD-HPR-R
₦82,000.00Add to cartGent S3 Red Body Voice Sounder High Power with Red VAD – S3-V-VAD-HPR-R S-Cubed offers a comprehensive range of loop powered alarm sounders with integrated voice and EN54-23 certified visual alarms. Combined with flexible configuration from the Gent by Honeywell fire control panels, this loop powered device can give a differentiated combination of audible and …
Gent Fire Alarm S3 Red Body Voice Sounder High Power with Red VAD – S3-V-VAD-HPR-RRead More
-
Out of StockGENT Fire Alarm way Sounder/Strobe Red Body Red Lens S3-SN-ST-RR 2
₦0.00Read moreHoneywells Sounder Beacon, designed and approved to meet both EN54-3 and EN54-23, is ideal for applications where a dual purpose audible and visual alarm device is required. A new folded horn design, high output LEDs, advanced optics and an innovative lens design, provides outstanding sound output and omni-directional light coverage at low current draw
-
Gents Fire Alarm Electronic Bells74430-88NM
₦12,500.00Add to cartDescription
An EN 543 compliant electronic bell for a wide range of applications. Available in red or grey metal casing and is suitable for both semi fl ush and surface mounting Honeywell Gent offers an electronic bell for a wide range of applications. The combination of a miniature solenoid with an integrated control circuit allows excellent sound coverage, minimum current consumption and increased reliability. The improved aesthetics make the bell suitable for all applications including the most prestigious locations. -
Out of StockKLAXON FLASH GUARD FIRE ALARM SYSTEM-LED BEACONS QBS-0060
Read more- Compact, ultra-modern sleek appearance
- Long life Led design
- Ease of installation with first-fix option on standard models
- Weatherproof to IP65, up to IP67 with a separate cable connector
- White, high-quality polycarbonate housing
- Vandal-resistant safety locking mechanism
- Flashing or Static Indicators
- 11-35VDC (Flashing or Static) 240VAC (Flashing Only)
- Current: 11-35VDC (50mA) 240VAC (32mA)
- Flash Rate: 1Hz
- Operating temperatures: -20c – +70c
- IP Rating: IP65 (Standard) IP67 (with cable connector)
Know Us
Safetech.hub is the newest online platform envisioned to provide 24/7 online platform for integrators, installers, and end users of Extra Low Voltage (ELV) systems in Nigeria
Read More
